Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - upscope757

Pages: [1] 2 3 ... 9
1
Restoration / Re: 1967 Pinstripes
« on: April 06, 2018, 11:02:53 PM »
Thanks! I assume as it was a RS it would have had the pinstripe right? Thanks again!

2
Restoration / 1967 Pinstripes
« on: April 06, 2018, 08:25:03 PM »
Hey all, I have read through some threads about the double pinstripes across the top of the fenders, doors and quarters. I do have an RS/SS car. Pinstripes would have come on this car correct? Also, where is the best place to purchase the pinstripes? Tks!

3
Restoration / Re: Vinyl Top Clips
« on: March 23, 2018, 10:03:37 PM »
Thanks! I will look them up.

4
Restoration / Vinyl Top Clips
« on: March 22, 2018, 12:27:19 AM »
All,
Where can I get a good set of clips for my vinyl top? The clips that came with the trim were plastic and the trim isn't snapping tight for a couple of clips. Thanks!

5
Restoration / Re: Under hood color
« on: June 29, 2017, 10:29:32 AM »
Thanks all!

6
Restoration / Re: Under hood color
« on: June 28, 2017, 09:28:55 PM »
Tks. Were the sides of the hood then body color with the underside receiving body spray? Or did even the sides of the hood, fender components that wrapped into the engine compartment onto inner fenders, header panel and valance edges also body color or oversprayed? Tks again.

7
Restoration / Under hood color
« on: June 28, 2017, 09:12:49 PM »
All,

Finally read to go to paint.

Is the under side of the hood body color or black? I had always thought body color but someone recently told me otherwise. Just want to make sure.

Thanks!

8
Restoration / Re: 67 Camaro Rear Seat - RS
« on: December 23, 2014, 11:49:15 PM »
Realize that.

Meant Deluxe.

Do RS's come with standard? I have only seen Deluxe.

Mine has deluxe. The seat came out of a 68' Firebird coup with armrests.

I should be fine.

Traded straight across for some frame rails that I had from 10 years back so I am satisfied.

9
Restoration / Re: 67 Camaro Rear Seat - RS
« on: December 23, 2014, 02:47:36 PM »
Thanks a million! I did realize they were the same width, but did NOT realize they were different between coupe and convertible.

Thankfully these came out of a coupe!

10
Restoration / Re: 67 Camaro Rear Seat - RS
« on: December 18, 2014, 11:52:14 PM »
Thanks a million.

Will be trashing the older upholstery anyway and putting the correct camaro covers on it.

11
Restoration / 67 Camaro Rear Seat - RS
« on: December 18, 2014, 10:13:17 AM »
All,

I need to replace my rear seat, 67 Camaro RS. My dad found one out of a 68 Firebird that is in pretty solid shape. Will it interchange both in fit as well as upholstery?

Thanks,
Matt

12
Restoration / Re: Original versus New Sheet Metal
« on: May 11, 2014, 01:42:12 PM »
Thanks a million. I will get some pictures here soon.

AMD? Revealing ignorance here I realize.... American... something or other...?

13
Restoration / Original versus New Sheet Metal
« on: May 10, 2014, 10:49:08 AM »
All,

I am looking for some thoughts on the lengths I should go to save the original sheet metal. I don't have a numbers matching car, but do have a correctly coded SS350 for what would have come with the car. I have all original sheet metal at the moment (but did pick up a new SS hood as the first one was really damaged badly). Both front fenders and the driver side door have a fair amout body work that would need to be done as with the front valance.

How much should I fight to save the original sheet metal versus just buying new? Where do folks recommend for quality/fit if I do go with new?

Thanks,
Matt

14
Restoration / Re: '67 Roofrail Weather Strip Channels
« on: April 14, 2014, 11:28:38 PM »
Thanks a million all.

15
Restoration / '67 Roofrail Weather Strip Channels
« on: April 09, 2014, 10:29:08 AM »
All, what is the best adhesive product to install the roofrail weather strip channels above the windows? A wide flat foam type strip is what came off of it originally.

Thoughts?
Thanks.

Pages: [1] 2 3 ... 9