Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Michaels69LM1

Pages: [1]
1
Mild Modifications / Re: 69 Camaro Auto Trans Swap
« on: May 18, 2011, 02:55:32 PM »
Hey guys any suggestions on clutch pressure plates, I'm leaning towards Hayes 11" but I'm open to suggestions. Also it looks like I may have to cut a hole in my floor for the shifter, whats the best way to line this up correctly? Any help is greatly appreciated

2
Mild Modifications / Re: 69 Camaro Auto Trans Swap
« on: May 05, 2011, 05:43:24 AM »
Thank-you, I have a much better idea of what is going to be the right muncie, I appreciate the help.

3
Mild Modifications / Re: 69 Camaro Auto Trans Swap
« on: May 02, 2011, 02:42:53 PM »
William, thanks for the reply. In your opinion what 1st gear ratio would be best? 2.52 or Lower? I really don't drive the car on the highways and would like the torque off the line. Your thoughts?

4
Mild Modifications / 69 Camaro Auto Trans Swap
« on: April 30, 2011, 04:41:30 PM »
Hi, I'm new to the forum and need some advice. I have a 69 LM1 Camaro with 350 - turbo 350 auto trans that I would like to swap for a 4speed, Console car horseshoe shifter. The question is which 4 speed?  I have contacted a few people in the industry some suggest the M20 wide ratio other suggest the M22 Close ratio. I have considered the tremec tko500 for the overdrive, but would like to keep the somewhat of the originality of the muncie trans.
I will be swapping the 350 engine 255hp for a 383 stroker with 525hp. also have 3.73 gears in the 12bolt.
Would I need to change the drive shaft and trans cross member with this trans swap?
Any help would be appreciated....

Pages: [1]
anything