Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - wisemanz28

Pages: [1] 2 3 ... 16
1
General Discussion / Re: Holley Carb Issues
« on: June 10, 2023, 08:11:41 PM »
Danny I was having very similar condition on my 4150 carb. It sounds like a vacuum problem. Mine turned out to be caused by my power brake booster, it had a bad front cup seal.

2
General Discussion / 1969 Camaro brake booster
« on: June 03, 2023, 05:11:46 PM »
I need to replace the rubber seal that goes on the front of the power brake booster (directly behind the master cylinder). Does anyone know where I can find this part?

3
Decoding/Numbers / Re: 67 Z28
« on: October 05, 2022, 04:33:38 PM »
It turns out the owner passed away and the family is selling his cars , 2 El Caminos and 1 Camaro. I  don't think the family knew much about the cars. I  passed on the info from the members to him, thanks guys. 

4
Decoding/Numbers / 67 Z28
« on: October 04, 2022, 11:55:58 PM »
I have a friend looking at a 67 Camaro. The seller claims it is a real Z28, I'm attaching a picture of the trim tag and one of the car. I did do some decoding of the tag and it looks like it came with a 3-speed floor shifter for M15 or M13 ( 2B ). I not familiar with the 67 trim tag and  I was wondering what you guys think of this tag.

5
General Discussion / Re: 4053 carb power valves
« on: April 22, 2022, 11:13:07 AM »
I also am seeing a number 6, I just wanted to be sure.

6
General Discussion / 4053 carb power valves
« on: April 22, 2022, 12:09:38 AM »
Trying to figure out my power valve size. Wanted to share the pics and get the groups opinion. The first pic is the primary side, second pic is the secondary side

7
General Discussion / Re: 4053 carb rebuild
« on: December 19, 2021, 08:44:55 PM »
I have Chem dip but didn't  know if it was too harsh on some brass parts.

8
General Discussion / 4053 carb rebuild
« on: December 16, 2021, 10:24:28 PM »
What chemical do you guys use to clean your disabled carb

9
General Discussion / Holley 4053 Carb
« on: November 06, 2020, 01:00:57 AM »
I want to rebuild my Holley 4053 carburetor. What rebuild kit would you guys recommend.

10
General Discussion / Re: '69 Huggar Orange Z/28
« on: September 11, 2020, 01:49:40 PM »
I Love Hugger Orange Z28,S , good luck with the car

11
General Discussion / Re: 69 Z is running rich
« on: July 20, 2020, 01:48:47 PM »
As I mentioned in a prior post I'm not sure I'm reading the guage correctly,  I tried to post a picture of the guage but the file is to large. There is two sets of numbers on the guage, the outside number  reads 20 , the inside number reads 8. Apparently I read it wrong. The car is all stock and I've owned it for 32 years

12
General Discussion / Re: 69 Z is running rich
« on: July 19, 2020, 09:23:34 PM »
I have a picture of the guage reading but the file is to large to post

13
General Discussion / Re: 69 Z is running rich
« on: July 19, 2020, 06:20:14 PM »
Adjusted the floats, the rear was too high and the vacuum needle is bouncing  between  19 and 21. I  could be misreading the guage,  what should be a normal vacuum reading for a 302?

14
General Discussion / 69 Z is running rich
« on: July 19, 2020, 12:25:45 AM »
Ive been trying to figure out why my 302 is running rich and fouling out my plugs. Today I put on a vacuum gauge and it read 20 to 22 and the needle was not steady, it was bouncing. I thought maybe the valve's needed adjusting , did that with no change. I'm not sure if its in the carburetor. Plug wires are new, points were cleaned and reset, distributor cap looks good. Looking for suggestions.

15
General Discussion / Re: Dated sparkplug wires
« on: June 22, 2020, 11:04:34 PM »
Thanks guys great info

Pages: [1] 2 3 ... 16