Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Reederv

Pages: [1]
1
Restoration / Re: Dip stick for 68 z
« on: April 10, 2009, 06:07:50 PM »
Paul, I'm Sorry I put through any trouble. I guess I mis understood. I thought you had already sold it, because i didn't get back with you right away.  Anyway, a freind might have one that's supposed to be like brand new. Seeing is believing! I guess i'll see.  If not I'll get back with you.  Thanks for your trouble, Vernon

2
Restoration / Re: Dip stick for 68 z
« on: March 29, 2009, 02:10:00 PM »
Well thanks Everyone for the info,. However I'm stiil looking. If anyone knows were one is laying around I would love to buy it! Thanks, Vernon

3
Restoration / Dip stick for 68 z
« on: March 28, 2009, 11:31:59 PM »
I''m looking for A correct dip stick for a 68 Z.  It has a gray tip!

4
Maintenance / Re: new clutch fades when hot !
« on: March 01, 2009, 01:12:38 PM »
Well, Thanks for having me in the club! New guy here!  Yea, this clutch has been a my thorn in my side, I'm hearing what everyone is saying, and i'll need to go back to the drawing board.  I'll check free play with the pedal fully up, then press down to see when I feel pressure.  I made need to adjust the rod some more, the new clutch sure feels great , I was just alittle puzzled, after driving. Something definitly changes after it's hot!  Thanks everone for the input i'll let you know what I do to fix this problem. As soon as THE SNOW STOPS!!!!!

5
Maintenance / new clutch fades when hot !
« on: February 28, 2009, 02:59:41 PM »
I have a slight problem with my 4-speed. When the car is cold my clutch works fine. Free play is about 2- inches from the floor. But after a good long drive, When I try to back up it grinds. Most of the time I shut the car off, then put the trans in reverse, Then restart the car. Happens rvery time!  Any suggestions!

6
Restoration / Re: 1967 exhaust system ?
« on: February 22, 2009, 05:51:02 PM »
Hey Mike, I have a 68 z, I replaced my exhaust last year, Ibought it from Gardners Exhaust, They are in New York. They only make muscle car Exhaust! It comes correct with everything you need, and blue prints to install it! I love mine. They will tell you just what is correct , and needed for your car.  Go on line check them Out
Vernon  Md.

7
Restoration / Re: Im Looking for this motor! ...
« on: February 17, 2009, 11:31:06 PM »
Thats ok! Trying to find the motor that came out of my car is nearly impossible.
The motor I have, came from a 69. for right now the DZ will have to do. I have ran into some people who claim to have an MO motor, When I ask, what are you going to do with it? They don't know!  By the way Carolina Machine Engine, Balanced and blue printed my eng. This 302 Run Great!! Talk at ya later

8
Restoration / Re: Im Looking for this motor! ...
« on: February 14, 2009, 05:54:04 PM »
Ok ! thanks

9
Restoration / Re: Tail lamp gaskets 1968
« on: February 14, 2009, 05:38:42 PM »
I found that the gasket, is only part of your problem..
You need to use a slight bit of sealer were the lens meets the metal housing.
I went down this road before, I took the entire housing off and filled it with water were the bulbs would nomaly go, only to watch the water to run run out.
Look very carefully at were it us leaking you will be suprised.

10
Restoration / Im Looking for this motor! ...
« on: February 14, 2009, 05:31:04 PM »
Hey guys, I have a 68 -z but the mo motor is missing. here's what i'm looking for.8n477480.  Thanks  Iwill keep looking!!

Pages: [1]