Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - bdgiesen

Pages: [1]
1
Originality / Re: 67 coupe rear end
« on: February 07, 2008, 06:28:55 PM »
OK I checked the codes and I am running 3.08 gears. That figures to about 3670 RPM at 70 MPH. That seems to high for a 3000 lb car. Any suggestions?
Brad

2
Originality / 67 coupe rear end
« on: February 05, 2008, 04:27:49 PM »
I have a 67 6cyl  3 speed saginaw car that I am putting a 350 with a 4 speed muncie. My quesion is how do I tell what rear end I have. With the 6 cyl it seemed to wrap pretty high at 65 mph. Also what would anyone recomend for a rear end gear for a good hiway car.
thanks Brad

3
Mild Modifications / 67 Power Steering Pump bolts and spacers
« on: November 30, 2007, 04:14:27 PM »
Does any one have a picture of a 67 small block with power steering. I need to know what bolts to use to mount the pump to the bracket and where the spacers go if any.
Thanks
Brad

4
Restoration / Re: 67 68 power steering brackets
« on: November 17, 2007, 02:25:16 AM »
Rick's has the correct brackets for '68 350.

www.rickscamaros.com

You need to get the correct pulleys too.

I have all the pulleys except for the water pump pulley for a L-48 w/o smog w/C-60 and N-40 config and it does have the 8" balancer

5
Restoration / 67 68 power steering brackets
« on: November 16, 2007, 04:31:28 AM »
I am puting a350 in my 67 car to replace the 6 cyl. I am also adding power steering and need to now what brackets to use and where to find them.

6
Mild Modifications / Swap 250 CID 6 for 350 CID SBC
« on: November 15, 2007, 03:52:26 PM »
 I am swaping the 6 for a 350. I need everything. brackets, pulleys, exhaust manifold (ram horn?) motor mounts. I am staying with the 67 set up with the alternator on drivers side. I also have vintage air and am adding power steering. Any help locating parts or advise would be greatly appreciated.
Thank you in advance
Brad

Pages: [1]