6
« on: March 17, 2007, 02:05:54 AM »
this is the guys Q&A
Do any 1969 L35 (396, 325 hp) have a single fuel line? I believe I have a 1969 RS/SS and everything seems to check out except the lack of dual fuel lines. It does not have any evidence of dual lines at the sender or along the attachment points under the body.
Also this is great site with a lot of information. I greatly appreciate all the hard work that goes into develping and maintaining it.
I assume this is the date stamped on the right front. It reads T1130TG which would be Nov. 30 1968? The block date cast date code is K 1 8. I am not certain the heads are original as they have a date code of K 29 8. Would it be odd for the engine to be assembled the following day? I am very new to these codes and only know what I see on CRG. The transmission was replaced in 1980 when I purchased the car, my dad later discarded it. No one seemed to mind changing anything else from original so I would be suprised it someone went to the effort of restamping the VIN on the block. The rear axle ratio was 3.07:1 the guy I brought the car from gave me the original ring and pinion. It has 4.11:1 right now. I can't find the rear end codes written down anywhere, I will have to get it from the car later. I have never paid attention to the location of the brake line bracket, I will check that also. Thanks.
Is there a reason someone would change the fuel line and tank sending unit? The car was modified significantly in the 1970's with aftermarket aluminum intake, headers, holley carb., etc.. It seems like a lot of trouble to go to remove the lines and replace them with an original looking single line. Everything else appears valid including JG engine code and block casting # 3955272. Any other thoughts?
First to answer the remaining questions from the prior post. I checked a few things tonight. The rear axle BR 1130G1 it has an E below. BR so that is a 3.07 positive traction 12 bolt, all checks. 1130 November 30th which also seems to check to the date of my car. G=Detroit, 1=first shift and E=Eaton positive traction unit. The front brake line brackets are on top of the frame.
I also looked at the heater core and verified the hose exit location for a big block.
Yes, it is a 12A Norwood car. I will need to remove the back seat and check for x codes, I don't recall anything like that from previous times the seat was out.
you got it all wrong
dud you really need to read before you give your advice 1 point taken back!
all im saying if you cant say it is a big block then dont say it not
jay
ps if your going to remove the tank to change the sending unit to a single i know i would take the line out like i said it just takes a few min