Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jherold

Pages: [1]
1
Maintenance / Re: Front Bumper 69 Outer Bracket Fastener
« on: May 05, 2020, 01:39:58 PM »
Hey Joe, while I've got you....
I have that AIM manual but I have a heck of a time finding anything without paging thru the entire book. Any hints on how to use this thing?  It seems so random. -John

2
Maintenance / Re: Front Bumper 69 Outer Bracket Fastener
« on: May 05, 2020, 01:23:52 PM »
You rock.  Thanks man. 

3
Maintenance / Front Bumper 69 Outer Bracket Fastener
« on: May 05, 2020, 11:56:13 AM »
I have scoured the internet and these outer brackets on my 69 front bumper just aren't in any assembly diagram I've ever seen.  Mine were missing when I bought it in 77.  Finally decided to get the brackets and rubber washer, but does anyone know what bolt and fastener is used?  I think the rubber washer and insert are over-sized to allow for adjustment because they are way bigger than the square hole in the bumper, that looks like it gets a standard chrome carriage bolt.   I'm sure someone out there has messed with this before me??  All suggestions welcomed.

4
Maintenance / Re: Resistance Wire going to Ignition Coil
« on: May 05, 2020, 11:52:17 AM »
Thanks Steve.  Yeah, that is an option.  I chose the Mallory dist because it didn't scream  "MODIFICATION" but your right that it isn't stock.  What a pain in the A__ those points are though!   Weird you can't just find that resistance wire......... (Unless you want to lay out another $150 for the entire harness, lol)  Have a goodun.

5
Maintenance / Resistance Wire going to Ignition Coil
« on: April 27, 2020, 03:42:29 PM »
I too have an HEI Mallory Distributor, to get rid of points, and it requires use of the resistance wire that drops down supply voltage to the coil while in run.  However,  mine is looking kind of worn and burnt.  I've noticed that it will burn its way out of the plastic electric tape wrap of the harness over time.  Is this normal?  It makes sense that it would get warm, being a resistor, but how warm?

Does anyone know where I can buy JUST the resistance wire without having to purchase the entire harness?

Pages: [1]