Show Posts
1
Restoration / Re: Sheet Metal and Frame Rust removal
« on: November 08, 2009, 05:45:09 PM »
I am working in the rear of the car. There is rust through in the rear quarter panels that I have
cut out an will replace. The same with the outer wheel wells. There is surface rust under and around the gas tank
area or the whole underside of the car. I was thinking of sand blasting the underside of the car. I have seen cars derusted using these products with a pump and pool type set-up to recycle the fluid. I was wondering which way may be better.
cut out an will replace. The same with the outer wheel wells. There is surface rust under and around the gas tank
area or the whole underside of the car. I was thinking of sand blasting the underside of the car. I have seen cars derusted using these products with a pump and pool type set-up to recycle the fluid. I was wondering which way may be better.