CRG Discussion Forum
Camaro Research Group Discussion => Decoding/Numbers => Topic started by: crobjones2 on August 25, 2012, 11:44:17 PM
-
Was it common practice to grind the rough area by the oil filter prior to stamping the vin?
-
Nope. It's left rough.
Ed
-
makes me a little suspiciuos of this stamp :-\
-
I'm no expert but I'd call foul on that. Restamp "I" Think.
-
i will leave it to the experts, but it looks like they ground the paint off. could have left those marks.
-
Do you have a pic of the general area?
-
Here is the original pic, if you need a better shot let me know (keep in mind the block is still in the car)
- I read some where that if they mis-stamped a block at the factory they ground it off and re-stamped it - if this is the case, is there any way to possibly see the previous VIN?
-
and here is the transmission VIN stamp for comparison
-
I think it's original. Looks like the casting might have had some flash that was removed.
Do you have a pic of the engine pad?
-
here you go
-
and the full size pic
-
Thanks! No question, that's the original pad stamping.
-
its nice to be right every once in a while!