CRG Discussion Forum
Camaro Research Group Discussion => Originality => Topic started by: sixt9x33rs on February 07, 2012, 03:14:00 AM
-
Did all 69 manual floor shift cars have the floor board cut with a torch? Regardless of tranny type?
-
Dont know about all but mine is torch cut. Had a 69 GTO that looked like it was cut with a can opener.
-
Only factory 4-speeds are like that.
-
Ok, now I am getting somewhere...so if I had a factory 3 speed car and put a Muncie in it the shifter would probably hit the floor board in 2nd and 4th? I think I have a facotry 3 speed car. When I got my convertible it had an incorrect 4 speed Saginaw. So just trying to piece the facts together why my shifter hits.
Thanks,
-
Ok, now I am getting somewhere...so if I had a factory 3 speed car and put a Muncie in it the shifter would probably hit the floor board in 2nd and 4th? I think I have a facotry 3 speed car. When I got my convertible it had an incorrect 4 speed Saginaw. So just trying to piece the facts together why my shifter hits.
Thanks,
Check this thread out.....Post # 3 has some templates for the hole cutout. Compare it to your car and see if your cutout is the right dimensions.
http://www.camaros.net/forums/showthread.php?t=204752 (http://www.camaros.net/forums/showthread.php?t=204752)
-
Here are pictures of my cut out and the ring that fits the cutout. The screw holes line up. Looks like it was a 3 speed to me.