CRG Discussion Forum
Camaro Research Group Discussion => Restoration => Topic started by: 69z28302 on March 21, 2011, 12:18:29 AM
-
I just got my clock back from being repaired. Went to put it in and the bulb socket wont fit. I have the blade type bulb in it that is oblong and it seems to bottom out. What bulb does it take? Rick's shows a console bulb but mine has a connector with the "push in" not twist bulb.
Thanks CRG
Mike
-
http://www.sylvania.com/ConsumerProducts/AutomotiveLighting/LampReplacementGuide/AutoLRG-Results.htm
Looks like a 168 bulb
For reference to other vehicles.
.http://www.sylvania.com/ConsumerProducts/AutomotiveLighting/LampReplacementGuide/default.htm
-
That looks like what I have now. The socket just wont fit in the clock though. It's like it's too long
Thanks
Mike
-
The AIM indicates part# 9425542 {bulb}...you must also have the correct Wire Assembly/Socket; part# 6297523 {note; the adjustment knob is a part of the wire ASM}
-
I'll check it again tomorrow.
Thanks
-
Here's the AIM sheet...
-
Looks like the clock base itself has been hot and is slight concave in it. I"ll have to figure out something to make the socket stay in the housing