CRG Discussion Forum

Camaro Research Group Discussion => Restoration => Topic started by: The Patch on October 27, 2010, 11:38:22 PM

Title: embarrassing question but here goes....
Post by: The Patch on October 27, 2010, 11:38:22 PM

I'm disassembling my '69 project and I've been searching for hours thru the '69 AIM. I cannot find where the screws and molding designations are that Wilbur the Wildcat is pointing to.  :-[

This is important because I am cataloging and labeling all the nuts, bolts, pieces etc. exactly as they are wrjtten in the AIM. To be consistent, I'd rather not write a verbal description of the pieces. If anyone can point me to the proper page where these things are located I'd be grateful.

Thanks!

(http://i29.photobucket.com/albums/c299/boates/SDC10030.jpg)

Title: Re: embarrassing question but here goes....
Post by: flyingskibiker on October 28, 2010, 12:07:49 AM

That information is in the Body by Fisher service manual.  But they don't really give any screw data, just that screws are used to hold on #3 in the picture ('68)...