CRG Discussion Forum
Camaro Research Group Discussion => Maintenance => Topic started by: ibfootin on May 29, 2010, 06:19:38 PM
-
OK. I need some help.
I was changing the rear axle seals (12 bolt posi). I am in the process of putting it back together when I see one of the thrust washers has fallen out from behind the spider gear. Is there a trick to sliding it back in behind the gear without messing the washer?
-
You might have to pry on it a little with a flattip to get all the slack out but it should slide in fairly easy. No special way of doing it.
-
I tried prying on the gear but it felt like I was going to damage the washer if I forced it too much under the gear
-
Pull the chunk and disassemble it and put it back in is the only other way I know of. No big deal just a little extra work. Be sure to torque everything back down.
-
Thanks. That is what I was thinking also