CRG Discussion Forum
Camaro Research Group Discussion => General Discussion => Topic started by: CR on January 02, 2010, 12:04:48 AM
-
I have a 67 396/325hp SS. I am removing the original engine and installing a 454 that I'm building. I want an aluminum intake that will allow me to keep the original SS hood. Will the 427/390hp Corvette intake work? Or is there a good aftermarket intake that will work?
-
Just use a stock L78 intake. It will even work with oval port heads if you pay attention to the gasket and will look like it belongs.
-
Charley,
How well does that configuration work? I would think that there are some draw backs?
Bob
Just use a stock L78 intake. It will even work with oval port heads if you pay attention to the gasket and will look like it belongs.
-
I've known guys that ran them for years. The square port intake is larger than the oval port heads and a good gasket seals fine. Flow doesn't seem to be bothered enough to tell.
-
Charley is right. We have done this several times before on customer's engines.
Jerry
-
I am confused ? CR do you have two car's ? or is this one the one you asked about in the other post that was all original never painted or bothered ? why would you remove an original 396 to reinstall a 454 ?