CRG Discussion Forum
Camaro Research Group Discussion => Restoration => Topic started by: jims68z on December 16, 2009, 05:46:36 PM
-
I purchased stainless fuel line for my 68 from Classic Industries. The lines was folded to fit in the shipping box. I straightened it out but can not seem to get the bends right to get into the engine compartment. It seems to fit well from mid door all the way back but I just can not figure out how it goes into the engine compartment and how the bends should be correct to transition from the rocker panel to the subframe.
Anyone have pictures or advice?
-
I put a single fuel line on my 68 Z and I had to put the car up on a hoist so I could get it up around the sub-frame and to the fuel pump. It fit real tight and I had to do some bending and twisting to get it in correct ???
-
I purchased stainless fuel line for my 68 from Classic Industries. The lines was folded to fit in the shipping box. I straightened it out but can not seem to get the bends right to get into the engine compartment. It seems to fit well from mid door all the way back but I just can not figure out how it goes into the engine compartment and how the bends should be correct to transition from the rocker panel to the subframe.
Anyone have pictures or advice?
See the illustrations in your Assembly Manual, UPC 8, sheet B3.