CRG Discussion Forum
Camaro Research Group Discussion => Restoration => Topic started by: vtfb68 on November 18, 2009, 02:26:07 AM
-
Hi guys,
I need help with the correct use of the 4 different mounting fasteners. for each side there are 11 mounting holes. 3 on the front fender, 3 on the quarter panel, and the rest on the door. the AIM only shows the front fender mounting. Does any one know where I can find another picture of the mounting? I can easly mount the trim, but I want it in the correct order.
Thank you,
Victor
-
Does any one know where I can find another picture of the mounting? I can easly mount the trim, but I want it in the correct order.
Victor -
The information you're looking for can be found in the 1968 Body by Fisher Service Manual. Section 17 is titled "Exterior Moldings".
Paul
-
Paul,
Thanks for the info. Will be on the look out for a copy.
VT
-
Hi guys,
I am still in need of the proper location (which hole uses which fastener) information, I did go through the Fisher book but could not find a picture or list of fastener order.
Paul, What page did you see this picture? The 68 B.B.F. book i purchased was printed AUGUST 1967 (Perfect condition for $10.00 from Louie @ the Long Beach Swapmeet) Any 68 Guys out there that remember the fastener order?
Thank you,
Victor