CRG Discussion Forum

Camaro Research Group Discussion => Originality => Topic started by: smith69z on August 19, 2009, 07:16:56 PM

Title: Endura bumper jacking instructions - different then standard bumpers?
Post by: smith69z on August 19, 2009, 07:16:56 PM

Did GM have a different sticker on the trunk lid for endura bumper equipped cars? And if so does anyone reproduce them?

Title: Re: Endura bumper jacking instructions - different then standard bumpers?
Post by: JohnZ on August 20, 2009, 03:18:49 PM

The Assembly Manual doesn't show a unique-to-VE3 jack instruction sticker either in the VE3 section or in the UPC 10 jack section.

Title: Re: Endura bumper jacking instructions - different then standard bumpers?
Post by: smith69z on August 23, 2009, 10:54:47 AM

Thank you for your time to answer John. I have been holding off on this sticker until I was sure.

Title: Re: Endura bumper jacking instructions - different then standard bumpers?
Post by: firstgenaddict on September 26, 2009, 07:06:12 AM

Here is an original paint VE3 vintage legend certified instructions
(http://inlinethumb05.webshots.com/43460/2434231010059464720S425x425Q85.jpg)

Title: Re: Endura bumper jacking instructions - different then standard bumpers?
Post by: Oaklyss on September 26, 2009, 07:55:53 PM

Heres my original paint car, original VE3, jack sticker:
(http://i145.photobucket.com/albums/r206/OAKLYSS/trunklid1.jpg)

Title: Re: Endura bumper jacking instructions - different then standard bumpers?
Post by: Oaklyss on September 26, 2009, 08:04:51 PM

Wait, heres a close up.
(http://i145.photobucket.com/albums/r206/OAKLYSS/trunklidsticker.jpg)

Title: Re: Endura bumper jacking instructions - different then standard bumpers?
Post by: crobjones2 on September 27, 2009, 12:22:53 AM

does anybody have any pics of the ""straps" used to hold the wrench to the jack?

Title: Re: Endura bumper jacking instructions - different then standard bumpers?
Post by: JohnZ on September 27, 2009, 02:31:37 PM

Quote from: Oaklyss on September 26, 2009, 08:04:51 PM

Wait, heres a close up.

That's the standard jack instruction sticker - same as my original non-VE3 '69 Z/28.

Title: Re: Endura bumper jacking instructions - different then standard bumpers?
Post by: JohnZ on September 27, 2009, 02:32:50 PM

Quote from: crobjones2 on September 27, 2009, 12:22:53 AM

does anybody have any pics of the ""straps" used to hold the wrench to the jack?

Don't have a photo handy, but they're wide, heavy black rubber bands.

Title: Re: Endura bumper jacking instructions - different then standard bumpers?
Post by: Oaklyss on September 27, 2009, 03:22:01 PM

My point is, they are the same. There is no speciial VE3 sticker.

Title: Re: Endura bumper jacking instructions - different then standard bumpers?
Post by: smith69z on September 28, 2009, 09:26:33 PM

Thanks guys!!