CRG Discussion Forum
Camaro Research Group Discussion => Mild Modifications => Topic started by: aaronz28 on June 05, 2009, 07:41:15 PM
-
anyone done this? i'm about to switch my muncie to a 2.87 first gear trans, with the original 4.10 rear gears.. so the car will have great 1st gear.
i am thinking of shelving the original flywheel and putting an aluminum lightweight flywheel.
anyone done this or have any suggestions on what to get?
Thanks
Aaron
-
I say don't do it if you drive it on the street! 302s don't have a lot of bottom-end anyway, and the inertia you'd lose would probably make the car hard to drive. Flywheels store a lot of kinetic energy, and a 302 needs all it can get. My 2 cents and good luck!
-
Ive driven a 302 with a lightweight flywheel, it revs quick but was a pig out of the hole for street I wouldnt do it- track fine- my .02c
-
That is a pretty good first gear. You may get away with it. I would try it because of the 4.10's too.
-
I have a light flywheel behind me 302 with a 296 1st gear and don't have any problems