CRG Discussion Forum
Camaro Research Group Discussion => General Discussion => Topic started by: Bjv69ss on March 17, 2009, 12:06:09 AM
-
Is there some sort of a tool I don't know about that rolles the sharp edge over at the bottom of the stainless gutter trim and makes it tight against the steel gutter on the roof. Before I destroy the stainless I thought I better ask. If there's no tool howthe heck is it done!!! :-\ ???
Thanks, Joe
-
Nope. It just takes patience. Jerry M. says aftermarkets are easier, I've only done origionals. Seems a lot of people destroy them as you say.
Read this: http://www.camaros.org/forum/index.php?topic=5059.0