CRG Discussion Forum
Camaro Research Group Discussion => Originality => Topic started by: Brandan on February 25, 2009, 03:26:41 PM
-
If I remember correctly, the assembly manual shows that the filler tube is attached to the tank by being soldered. My body guy says it is clamped on both ends with the rubber sleeve. When I did my '69 tank I remembered that the tank came with the filler neck attached.....
What is the correct way to mount the filler neck and be correct?
Brandan-
-
67-68 models used a filler neck that bolted to the rear body panel and used a 2 in. id. hose to connect the tank to filler neck. 69 filler necks were soldered to the tank.
-
Your body man is correct on that one! separate filler neck with rubber sleeve and clamps holding it together. Bill C.
-
thanks..... i will give it a try....
-
Both the filler neck and hose are still available from GM. part numbers 3893113 and 3834073 respectivley.
-
got em thanks......