CRG Discussion Forum

Camaro Research Group Discussion => General Discussion => Topic started by: paulsstuff on February 04, 2009, 03:10:38 PM

Title: '68 Power steering conversion
Post by: paulsstuff on February 04, 2009, 03:10:38 PM

 I recently picked up  a power steering box, pump, hoses, and brackets off a '67 Camaro and want to install on my manual steering '68. Should this simply be a bolt-in installation or are there components that differ? I know the pitman arm and steering arm are different and have aquired them new. But I'm not sure if the p/s cars used the same column as manual steering.

 Any help or info would be greatly appreciated. Thanks

Title: Re: '68 Power steering conversion
Post by: mrdetails on February 04, 2009, 03:18:44 PM

Column is the same.
Good Luck
Sam

Title: Re: '68 Power steering conversion
Post by: paulsstuff on February 04, 2009, 03:22:09 PM

 Fantastic. Thanks Sam.

Title: Re: '68 Power steering conversion
Post by: CVKUEBER on February 04, 2009, 04:11:41 PM

The rag joint between the column and gear box are different for manual and power steering.