CRG Discussion Forum

Camaro Research Group Discussion => Mild Modifications => Topic started by: 4ZNOW on January 02, 2009, 12:22:43 AM

Title: First gen camaros with Magnaflow True X dual Exhaust system
Post by: 4ZNOW on January 02, 2009, 12:22:43 AM
Looking for Some Info --- How well it fit's ,the sound compared to Flowmaster system , performance with X pipe VS True Dual Exhaust ,  any picture's of installed True X system , I will be connecting to Small Block with a set of hooker Headers , I have  Flowmaster 40's  set up on My other car but I like the Idea of a full stainless system ----Thanks
Title: Re: First gen camaros with Magnaflow True X dual Exhaust system
Post by: sdkar on January 15, 2009, 01:57:19 PM
I have the magnaflow 2.5" system on my 69 with a big block.  I chose the magnaflow for two reasons, the X pipe and it was all stainless steel.  It fit fine with some persuasion here and there, as would be expected on any system.  I used Hooker headers as well.  Highly recommended in my book. 
Title: Re: First gen camaros with Magnaflow True X dual Exhaust system
Post by: Z06vette on January 16, 2009, 08:24:38 PM
I have it on my 69 with a 350.  The center X section had to be trimmed for me (too long).  I guess it depnds on the headers used.  Much quieter than flowmaster.  Mufflers are straight thru design, so flow should be excellent.  I didnt use the clamps, had it welded.  It has been on for a year- about 3500 miles.  Finish still looks good- no rust or hazing.  Tailpipes fit well.  I dont care for the tailpipe exit configuration, but no big deal- personal preference.  I would definately buy another one. Scott
Title: Re: First gen camaros with Magnaflow True X dual Exhaust system
Post by: sdkar on January 17, 2009, 11:18:32 PM
Z06vette,

I sent you a PM.  Since you welded yours up and did not use your clamps, I would be interested in buying your leftover clamps.  Let me know if you want to sell them.

Steve
Title: Re: First gen camaros with Magnaflow True X dual Exhaust system
Post by: Z06vette on March 14, 2009, 03:26:16 AM
Steve, finally found the clamps.  Sent you an email.
Scott