CRG Discussion Forum
Camaro Research Group Discussion => Maintenance => Topic started by: 68Zproject on April 18, 2008, 05:20:33 AM
-
I have the original rubber boot that goes over the valve on the back of the prop valve on the MC. It has a small slit in it. I wondered what I could use to seal it up. Slicone? Latex? How about that stuff in the can that you can make plastic grips for your pliers by dipping them? Ideas? Thanks.
-
You can buy a reproduction one for less than $4.00...
http://store.heartbeatcity.net/store/product/12345/Brake-proportioning-valve-boot/
Paul
-
Thanks Paul. I thought I read on here a while back that no one reproduced it. Looks like they do.
-
The re-pops are terrible .I used some POR-15 on the inside and it sealed it up nicely .Clean with dish soap and water first .