CRG Discussion Forum
Camaro Research Group Discussion => Restoration => Topic started by: mrdetails on March 12, 2008, 04:31:24 PM
-
Hello all: Can someone please tell me the correct length for a 1969 Camaro driveshaft, center of u-joint to center of u-joint. Turbo 400 application. I'm not sure mine is correct. It's 48 3/4".
Thks. in advance.
Sam
-
Hello all: Can someone please tell me the correct length for a 1969 Camaro driveshaft, center of u-joint to center of u-joint. Turbo 400 application. I'm not sure mine is correct. It's 48 3/4".
Thks. in advance.
Sam
I'll measure mine tomorrow for you and post it up if there are no replies by then. I have TH400 sitting behind a BB motor.
-
Hello all: Can someone please tell me the correct length for a 1969 Camaro driveshaft, center of u-joint to center of u-joint. Turbo 400 application. I'm not sure mine is correct. It's 48 3/4".
Thks. in advance.
Sam
I'll measure mine tomorrow for you and post it up if there are no replies by then. I have TH400 sitting behind a BB motor.
49 1/2 inches
-
Thank You.........I've been on vacation, reason for the delay. I wonder why my shaft is different from yours, mine may not be from a camaro I guess. I'll have to do some more research.
Thks. again:
Sam