CRG Discussion Forum
Camaro Research Group Discussion => Maintenance => Topic started by: sdkar on October 24, 2007, 05:23:57 PM
-
Not sure if this is something new or just something I have never noticed before. The rear axles of my 69 Camaro have some play when I move the axle in and out. It is not much but I am wondering if it is contributing to a recent "rattle" noise I am getting while driving. What is the amount, if any, that the axles should move in and out? Is there anything I should do to take up this play?
Steve
-
A tiny bit is normal. There is a c clip holding the axle in. Maybe 1/8-3/16" ?
-
What is the amount, if any, that the axles should move in and out?
Steve -
The specification for the axle shaft end play is .002" - .020" You can check it with a dial indicator. :)
Paul
-
Got it measured and the tolerances are good. Found the rattle while I was at it. One of my exhaust pipes is hitting the underneath support plate that is on all convertibles.
Thanks for the info.
Steve