CRG Discussion Forum
Camaro Research Group Discussion => Restoration => Topic started by: 68rsssrag on April 28, 2007, 04:37:15 AM
-
Does anyone have a clue on what this part is and where it goes? I found it in my wndhield moulding box with a note i wrote saying it belongs on the windhield frame 2 3/4" off center on the drivers side. I cannot figure out where it goes.
Arno
-
Sorry for the typo...it was in the windshield moulding box for my 1968 Convertible.
Arno
-
I had a 69 vette years back and had a piece like that in the door jam like on the first gen camaro converts have.
-
This is soft rubber not hard plastic so i don't think its a rub strip. 1st gen Camaro rags have 3 rub strips on the hearder bow and this isn't one of them.
-
could i be a setting block on which the windsheild is set on
-
I can't remberber how soft that part is but it looks like a support that goes under the L/H header molding on the top portion of the winshield frame.
-
Sebastien
That makes sense. Is there only one (LHS only)?
Time to take off the header moulding anyway to have a look before the winnshield goes in.
Arno
-
yes only one L/H side.I sent you a picture.