CRG Discussion Forum

Camaro Research Group Discussion => General Discussion => Topic started by: Chuck-68-Cam on July 26, 2022, 08:11:37 PM

Title: General Question
Post by: Chuck-68-Cam on July 26, 2022, 08:11:37 PM

I am looking at my old install of the harness to fuse box. It looks like they had the box mounted of the fire wall liner. My new fuse box has a seal on it. Should I cut away that liner and mount the gasket directly to the inner fire wall or bolt it up over top like the old on was? I am thinking it should not be over top of the liner.

Title: Re: General Question
Post by: z28z11 on July 27, 2022, 01:53:22 AM

Right reasonably sure the seal goes flat on the firewall, else how would it seal ? I don't remember my firewall pad under the fuse panel when I took it out - try the AIM for the assembly sequence.

Regards,
Steve

Title: Re: General Question
Post by: Chuck-68-Cam on July 27, 2022, 01:26:21 PM

Thanks Steve.

Yea, I looked through it and did not see anything definitive. But I am with you. I think I will trim the liner to get that seal.