CRG Discussion Forum
Camaro Research Group Discussion => Originality => Topic started by: x66 714 on February 23, 2020, 04:44:46 PM
-
Does a 1968 302 use the lower plug wire looms with 2 slots or 3? Thank you, Joe
-
UPC 6
B5
3, assuming you mean on the valve covers,,3 slot dividers prior to the upper loom brackets.
-
So the one on the left is correct? Do you know what the on the right is for? Thank you, Joe
-
At some point I remember a thread about use of 2 vs. 3. I just went off the assembly manual. Are those survivors off your car? Mines a Norwood build, if that means anything.
-
Since it was supplied with the engine, it shouldn't matter if Norwood or LA. Mine is LA. Was just looking through parts & thought I would find out for sure. I'm not sure where the 2 wire ones came from. The 3 wire ones I purchased from Chevrolet in about 1977.
What do you have on your engine?...Joe
-
I put 3 both sides, came as a set, stamped, bk off the top of my head,I think.
-
Not original to the car, aftermarket.