CRG Discussion Forum
Camaro Research Group Discussion => Restoration => Topic started by: bobs69z on November 21, 2019, 12:41:09 AM
-
Does anyone have a pic. or part number for top radiator shroud bolt for a 1969 with 302 engine? thanks Bob
-
9419380. All small-blocks are the same.
Also used [2 pc] to secure the plastic fuel pedal support to the cowl and the clamp at the base of the steering column.
-
If someone could provide a pic, and if there are any markings on the head. My white 69 is in need of at least 1
-
Why not check the same screws in the other locations I noted?
-
That is what I am saying, I have 2 different kinds of bolts in those locations, and my shroud had a sheet metal screw. Maybe I can remove the 2 styles and post pics, and see if either are correct.
-
FWIW here's what AMK shows on page 78 of their catalog. I suppose as with most fasteners, there could be more than one supplier/head marking
https://www.amkproducts.com/wp-content/uploads/Catalog_BulkFastener/BULK_71-88.pdf
-
Thanks for the replies. I found the right ones at Heart Beat City. Using part#9419380.
-
9419380. All small-blocks are the same.
Also used [2 pc] to secure the plastic fuel pedal support to the cowl and the clamp at the base of the steering column.
William are you referring to the plastic moulded rectangular piece just below the steering column?
-
No; the metal trim plate clamped at the base of the column.
-
Thanks William for the idea to look for other places in the car that used the same fastener.
I looked at the Z10 I am restoring last night. A lot of stuff on it has been messed with over 50 years, but I am pretty sure these places had not been touched. The plastic gas pedal bushing and the steering column all had the same 4 screws that Pete showed, but with an E on the the head.
Now to convince the Legend Judges you don't need the small bolt with the big washer on the radiator shroud...
Mike
-
Ok I went through the AIM. Page 132 ( UPC 9 A4) shows the area under the dash where the clamp is, for those that may have trouble locating the 9419380 bolt/screw.
OK now when I look at page 147 in the AIM ( 11/13 B4), I see the clip (3939394) and the washer (120386) . Is there another location that the washer is used?
I put one on there for now but I know it is not right. thanks
(BTW my original screw/bolt has a "D" on it.)
-
Washer #120386 is not found anywhere else on a '69.
-
William your a wealth of knowledge, thanks for the help.