CRG Discussion Forum

Camaro Research Group Discussion => Maintenance => Topic started by: aaronz28 on September 21, 2019, 11:30:28 PM

Title: Z28 - 4053 mods when running the 140 cam
Post by: aaronz28 on September 21, 2019, 11:30:28 PM

Other than jetting -
Does anyone have any advice on tweaking a 4053 to run better when the 140 cam is used?
Idle or high speed air bleeds or anything

Thanks in advance?

Title: Re: Z28 - 4053 mods when running the 140 cam
Post by: PHAT69AMX on September 22, 2019, 05:26:11 AM

Use the SECONDARY Idle Speed Screw to set on-car idle speed after setting PRIMARY idle speed screw off the car to achieve optimum transfer slot exposure, and NOT CHANGE the Primary Idle Speed Screw once bench set.
Be sure to click continue ar bottom right to see page 2

http://www.candsspecialties.com/tuning.html