CRG Discussion Forum
Camaro Research Group Discussion => General Discussion => Topic started by: camaroman1969 on December 05, 2017, 02:03:24 AM
-
I would like to install a "defogger blower" on my 1969 Camaro SS/RS. Question: Does one have to cut dash, or is this already pre-cut behind the wood grain covering?? All comments will be appreciated. Thanks guys! Don
-
Not pre-cut. The woodgrain trim was pre-punched for the switch if the car was ordered with a defogger. Dimensions for the dash are shown in Section C50 page A1 of the Assembly Instruction Manual.
-
Thanks Bill. Doesn't look like its gonna be a easy task to install this defogger.
-
Nothing a dremel tool can't handle. Been there, done that.
-
I believe the woodgrain trim for a convertible with power top is the same.
-
There was also double bezel for convert top and rear window defog
-
Thanks guys for all your input. This will help.