CRG Discussion Forum

Camaro Research Group Discussion => Garage Talk => Topic started by: feastersss on April 15, 2017, 11:50:38 AM

Title: '68 Wiper motor issues
Post by: feastersss on April 15, 2017, 11:50:38 AM

I'm trying to install the crank arm on the back of the motor and I'm following the diagram in the assembly manual UPC 1 A2, if I hold my wiper motor following the picture, one alignment mark is opposite the picture, does anyone have a good picture of a '68 wiper motor (back view), I was told this was for a '68, can't find any #'s on it!

Title: Re: '68 Wiper motor issues
Post by: Camarocards on April 15, 2017, 04:59:49 PM

Here's my '68 wiper motor.

Bob

Title: Re: '68 Wiper motor issues
Post by: feastersss on April 15, 2017, 06:40:36 PM

Thanks!

Title: Re: '68 Wiper motor issues
Post by: z28z11 on April 17, 2017, 02:52:16 AM

If you want to be absolutely certain of the crank arm in the park position, temporarily mount the motor on the firewall (so it grounds properly), hook up all wiring to the motor and cycle it at least one time (on and off with the switch). Remove the motor, mount the arm and you'll be all set. The timing marks are not absolute - they can denote a range that the arm should fall in between.

Regards,
Steve

Title: Re: '68 Wiper motor issues
Post by: feastersss on April 18, 2017, 09:38:21 AM

Thanks, that worked great, appriacate the help!

Scott