CRG Discussion Forum
Camaro Research Group Discussion => Originality => Topic started by: 69z28rsbilly on May 03, 2016, 05:22:46 PM
-
Did the early 1969 Zl1 Camaro Intakes have casting numbers ?
As I have seen a lot of early "198"Factory Winters dated 1968 BBC open divider intakes with no casting number or the last three digits factory ground down and hand stamped 198, and some with a raised boss for the casting number but left blank.....
I was thinking of buying one without no casting mark but dated late 1968....
Thanks in advance....
-
The only builds that fit the "early" category would be #1 & #2 final-assembled December 30, 1968. Both had pilot engines built at Flint late November. It is possible they had hand-stamped intake manifolds.
-
Thanks William
Did the first two 69 ZL1 pilot engines have the casting number( or a number) cast in to the block(between the two ribs) above the timing chain cover ?
thanks
-
Only the block from #1 still exists. It is no different than the other known production ZL1 engines.
-
Thanks