CRG Discussion Forum

Camaro Research Group Discussion => Restoration => Topic started by: 67rs327 on August 02, 2015, 02:26:14 AM

Title: 1967 Tranmission cross member orientation
Post by: 67rs327 on August 02, 2015, 02:26:14 AM

So in my haste to remove the transmission cross member from my '67 (4 speed) - I failed to notice which side is forward (or aft?)
There's a single hole in the center section near the 2 main mounting holes - and also 2 smaller ones on one  side and a single directly across from those on the other side. Curious what these are for and what direction should the cross member be in for reinstallation? Thanks.

Title: Re: 1967 Tranmission cross member orientation
Post by: 1968 Z28 on August 02, 2015, 02:49:00 AM

The three small holes are for the shifter mounting bracket......therefore the crossmember would mount with them on the driver side.

Title: Re: 1967 Tranmission cross member orientation
Post by: 67rs327 on August 02, 2015, 02:55:30 AM

Thanks man. Knew someone had a quick answer to that.