CRG Discussion Forum
Camaro Research Group Discussion => General Discussion => Topic started by: dd69 on March 11, 2015, 12:50:32 AM
-
hi guys, i am new to the site ,but not to camaro's. i have had my 68 ss since 92 and i am in the middle of doing over a 69 . this one was a shell when i brought her home seven years ago.i have gone through a lot of different paint scheme ideas until about a month ago i decided to go with a motion paint job. i have since purchased a l88 hood and have looked at numerous photos, spoke to as many body guys as i could think of ,even did a search here but cannot find specs on the rear wrap around or single stripe down the middle. any suggestions that i haven't mentioned would be greatly appreciated. thanks dave
-
http://www.ebay.com/itm/Ertl-1-18-Diecast-1969-Baldwin-Motion-Camaro-Green-MIB-/381187165095?pt=LH_DefaultDomain_0&hash=item58c0868ba7
take a guesstamate off of this there was no exact pattern.
-
Since the paint scheme you are looking for was not factory, you probably won't find any exact dimension specs.
You could check out some old car magazines from "back in the day" to get an idea of dimensions.
-
Most all them differ and it depends on what you like...The phase 3 cars were striped like the green Mexican car to let everyone know it had the L88 installed....
-
yah i figured i would just put some tape on and see what i liked. i was asking just for a base line . thanks for the replies dave