CRG Discussion Forum
Camaro Research Group Discussion => Originality => Topic started by: L78 steve on January 26, 2015, 03:49:36 PM
-
The 69 front wheel opening moldings 3953635 and 36 do not have the holes drilled for the fender bolts? Is this so?
Thanks, Steve.
-
no holes
-
The original front wheel well moulding has the holes in it for the fender bolts. I don't know why they would not still come that way? That is how they are attached.
-
I was thinking small screw holes. Not sure on fender bolts. I tried to look but no luck. Wasn't there a second part number on these that were different by holes in them from the originals?
-
The NOS moldings I have has holes in them. They're for 67-68 though.
Bob
-
69 have the fender bolt holes. Some repros did not. I don't know about what is currently out there...
-
Rear wheel well moldings have small holes for the attaching screws. The screws should be included.
The fronts did not need screws due to the large fender bolts holding them in place.
-
Rear wheel well moldings have small holes for the attaching screws. The screws should be included.
The fronts did not need screws due to the large fender bolts holding them in place.
I believe there should be 2 screws for the front fender extension
-
Some Later Issue GM front wheel well mouldings came with no holes for some reason, a pain to drill unless you have originals to use as a pattern.
-
We stamped the holes and used a spare set of fenders for the pattern.