CRG Discussion Forum
Camaro Research Group Discussion => General Discussion => Topic started by: TX-302 on December 20, 2013, 09:54:16 PM
-
My Z has the original springs which are beginning to sag just a bit on the rear drivers side. Can someone recommend a vendor where I can get the front coil and rear leaf springs that will produce the proper ride height. Thanks
-
On rear it depends if you want exact look or not. I used a set of correct looking ones from Camaro specialties. For the front look up pozzi racings site or there should be discussion on here about them. I used the Moog 6308. There is one slightly stiffer for a z that might be better on an rs car. Z sits a little lower than a small block car so make sure you get the right ones. I learned after ordering the small block springs from hbc after they said that's what everyone uses. Car looked like motor was out