CRG Discussion Forum
Camaro Research Group Discussion => Restoration => Topic started by: scoop on October 31, 2013, 01:47:03 AM
-
Does anyone know where to find the correct rivets to rivet the ash tray to the front pull out. I disassembled it to refinish the parts separately and now need to reassemble it with the correct rivets. Any help would be greatly appreciated. I will send it out if there is someplace that will do it to the correct specs. Thanks,. Scoop
-
I finally found the correct rivets for the ash tray. I also purchased the tool to mushroom the ends correctly. If anyone needs theirs done send the pieces to me and I will rivet them for you. Pictures of the finished product are attached. Scoop
-
Very nice.. :)
-
Can you post a Pic of the tooling?
Jim W
-
Here are some pictures of the tool where it can be purchased. Need anything else let me know. Thanks, Scoop
-
Nice.
Assuming: Semi-Tubular Rivet, 1/8x1/8 In
Good job. Thanks for sharing.
Jim
-
Yes 1/8 inch by 1/8 inch semi tubular rivets. They are for rebuilding Tonka Trucks. Thanks, Scoop