CRG Discussion Forum
Camaro Research Group Discussion => General Discussion => Topic started by: sdkar on October 08, 2013, 01:20:17 AM
-
Hey guys,
I am painting my 69 with the Baldwin Motion paint scheme, complete with rear wing and stinger hood. It will have the center stripe down the hood, roof and trunk, with the wrap-around on the back end, and the hockey stick stripes on the side.
If anyway can tell me the measurements or where I can find this info, I would greatly appreciate it. For example, how wide is the single stripe? How far up does the rear wrap-around stripe go, etc.
Thanks.
-
Do you have photographs?
-
Just what can be found on the internet...but nothing detailed. Is there a site you recommend or pics you can send?
-
I think I have an original magazine from '68 which had their ads and an article or two? although I haven't looked at them in years.. :) if it would do you any good, I could go look. I have all my older magazines cataloged and grouped by years and type..
PS. Does anyone want to buy a few hundred (or is it thousands) car magazines dating to the '67 or so timeframe?? HRM, PHR, CC, HPC, etc.. :)
-
Hey Gary....Look at the last Car Craft magazine....Car Craft is actually looking for old magazines in that time frame ..Scott
-
If you have any of the magazines you can scan and post here or send me, that would be great.
Thanks,
Steve
sdkar@bellsouth.net
-
If you have any of the magazines you can scan and post here or send me, that would be great.
Thanks,
Steve
sdkar@bellsouth.net
I sent you about 6 photos of Kevin S Daytona Yellow 1969 Motion car, they are overall photos and you might be able to get a idea of stripe locations.
Check your email
Jim
-
I might be able to help with this since I'm doing a real phase 3 car....................RSR