CRG Discussion Forum

Camaro Research Group Discussion => General Discussion => Topic started by: Danishbanker on July 01, 2013, 09:23:15 AM

Title: 1967 Camaro Generator bracket - what to do ??
Post by: Danishbanker on July 01, 2013, 09:23:15 AM
Hi

I have put on som shiny valvecovers that are a little bit taller than the original ones, - because of that the generator fan belt had to be chanced to one 1" longer but now my generator tighten bracket os not long enough so I can tighten the fan belt :-((

My info is:

* 327 engine without bolt holes in the head
* Short water pump
* Original cast iron exhaust manifolds that hold the lower generator bracket

What have you guys done? hope to get som helping info ;-)

/Claus, Denmark