CRG Discussion Forum

Camaro Research Group Discussion => Originality => Topic started by: rsr on April 05, 2012, 05:13:21 PM

Title: 67 4P no radius rod
Post by: rsr on April 05, 2012, 05:13:21 PM

 Is it possible to have a 67 SS  4P car 12 bolt without the radius rod from the factory? Thanks

Title: Re: 67 4P no radius rod
Post by: 1968RSZ28 on April 05, 2012, 05:18:11 PM

Quote from: rsr on April 05, 2012, 05:13:21 PM

Is it possible to have a 67 SS  4P car 12 bolt without the radius rod from the factory? Thanks

Yes...  http://www.camaros.org/radiusrod.shtml

Paul

Title: Re: 67 4P no radius rod
Post by: x77-69z28 on April 05, 2012, 10:42:16 PM

i purchased my 12D 67 rs/ss from the original owner in 1984. he stated that the car went back to the dealership to have the radius rod installed. it is the square bar. the warranty guys at ther dealer didnt use the inside floor brkt, they just used bolts with biug washers. probably making two dollars an hour back then.

Title: Re: 67 4P no radius rod
Post by: Mike S on April 05, 2012, 10:46:54 PM

So how was the front of the bar mounted if not floor bracket was installed? Bolted through the frame?
The square bracket also used a smaller bracket with a rubber snubber attached to it. Was that installed too?
Can you provide a picture?

Mike