CRG Discussion Forum

Camaro Research Group Discussion => Restoration => Topic started by: zman1969 on March 13, 2012, 07:59:27 PM

Title: windshield lower trim screw size and type info needed
Post by: zman1969 on March 13, 2012, 07:59:27 PM
ready to install windshield trim and as you know the lower trim has clips and screws to attach to the cowl. I have searched forums and venders and what i have found is they are 5/16" hex head screws anybody know what size screw and the length? pics would be nice if you have any too!
Title: Re: windshield lower trim screw size and type info needed
Post by: PURESS on March 13, 2012, 09:50:23 PM
under search....     Documenting 1969 Fasteners
Marty did an excellent job   check there
Title: Re: windshield lower trim screw size and type info needed
Post by: zman1969 on March 13, 2012, 11:09:01 PM
I searched that and got this thread- nothing else
Title: Re: windshield lower trim screw size and type info needed
Post by: 1968RSZ28 on March 13, 2012, 11:22:23 PM
Quote from: PURESS on March 13, 2012, 09:50:23 PM
under search....     Documenting 1969 Fasteners
Marty did an excellent job   check there

Quote from: zman1969 on March 13, 2012, 11:09:01 PM
I searched that and got this thread- nothing else

Here you go...  http://www.camaros.org/forum/index.php?topic=9074.0

Paul
Title: Re: windshield lower trim screw size and type info needed
Post by: 67 RS Ragtop on March 14, 2012, 03:21:51 AM
ZMAN

  email sent
Title: Re: windshield lower trim screw size and type info needed
Post by: zman1969 on March 14, 2012, 03:27:16 AM
that's a good article but didn't see what fasteners I'm looking for
email replied to
Title: Re: windshield lower trim screw size and type info needed
Post by: 69Z28-RS on March 14, 2012, 04:19:18 AM
Hi Rich,
I replied to your other message re your car; good luck on it!  :)

Since my cowl panel is off (since last week) when I saw your message i went down and took a couple of photos trying to get a pix of the screw head.  Actually, all of the screws under my windshiield were the same, but some appeared to have blank head markings (or maybe 43 yrs of crud?).. :)
Anyway, I removed one and then searched in the AMK catalog to see if I could find a match.  Attached are the photos I took.   I think AMK number B-11085 is the same (but different head marking)..
The first photo is with the screw lying beside the B-11085 in the catalog; the second is the best pix I could take of the head marking..  appeared to be a circle...?