CRG Discussion Forum

Camaro Research Group Discussion => General Discussion => Topic started by: Bjv69ss on February 27, 2010, 06:50:26 PM

Title: Wheel well moldings
Post by: Bjv69ss on February 27, 2010, 06:50:26 PM

Has anyone used the OE Reproduction Wheel Well Moldings from Rick's PN# WW-7 in the new catalog?  My car has Good Mark sheetmetal all around.  The cost of the nos stuff is just out of the question for me.  I've tried some aftermarket moldings from eBay...I think they were supposed to fit on a Toyota or something.  They were not even close to fitting a 69 Camaro!

Title: Re: Wheel well moldings
Post by: gro51 on February 28, 2010, 12:17:28 AM

Absolute crap.  Paper thin and not even close on the fit.  >:(   But that was about 3 years ago.  Maybe they have a better supplier now?  I'm just going without wheel well moldings until I hit the lottery.

Title: Re: Wheel well moldings
Post by: RamAirDave on February 28, 2010, 04:37:40 AM

There was one report on TC of someone using the newly-tooled moldings about maybe a year ago.  Supposedly a lot better than the old ones.

Title: Re: Wheel well moldings
Post by: Bjv69ss on February 28, 2010, 01:14:25 PM

What's TC?

Title: Re: Wheel well moldings
Post by: Indy 69 on February 28, 2010, 01:45:02 PM

Quote from: RamAirDave on February 28, 2010, 04:37:40 AM

There was one report on TC of someone using the newly-tooled moldings about maybe a year ago.  Supposedly a lot better than the old ones.

I have also heard from another source that the newly tooled moldings were much better, but I have no first hand knowledge of them though.

Quote from: Bjv69ss on February 28, 2010, 01:14:25 PM

What's TC?

Team Camaro
camaros.net
 8)