CRG Discussion Forum

Camaro Research Group Discussion => Restoration => Topic started by: boomer632 on April 20, 2023, 01:37:45 PM

Title: Part ID
Post by: boomer632 on April 20, 2023, 01:37:45 PM

Can anyone ID what these parts are and the intended use? Im missing them and need to find and install.

Title: Re: Part ID
Post by: x66 714 on April 20, 2023, 01:44:21 PM

Seat belt anchors for the rear seat...Joe

Title: Re: Part ID
Post by: boomer632 on April 20, 2023, 02:00:44 PM

I have holes there but my rear 3 sets of rear seatbelts are installed. Im going to post photos later of whats going on there.

Title: Re: Part ID
Post by: 169INDY on April 21, 2023, 01:42:37 AM

Could that (Missing) be a symptom of Reproduction floor pan replacements w/o transferring the nut-reinforcements from orig's?

Title: Re: Part ID
Post by: boomer632 on April 21, 2023, 11:42:07 AM

The floors and trunk are original to the car. Im not sure what part of the seatbelt system would attach to those. The holes seem to be pretty high up. I got as far as removing the rear seat last eve. Got one of the sides on bottom seat, other side is fighting me. Will try again this eve

Title: Re: Part ID
Post by: 169INDY on April 21, 2023, 03:17:51 PM

The Belt "ANCHOR" end, i.e. end opposite the Latch or catch.
Seat Rears; Stacked.
There are some good reference photos in the report.
http://www.camaros.org/seatbelt.shtml

Title: Re: Part ID
Post by: boomer632 on April 21, 2023, 07:58:22 PM

So after getting under the car to verify the belts, I found that the anchors are in place and all is good. The mystery holes, 4 of them are up in trunk near divider. Here are the 4 holes I am wondering about. Maybe something another owner had installed but was taken out? Seems like a weird place to mount something without removing that piece of metal that is sticking up. Not sure why that is there either.

Sorry for the confusion on this. I just got the car and am going over it.