CRG Discussion Forum
Camaro Research Group Discussion => Originality => Topic started by: rod396 on July 26, 2018, 06:59:41 AM
-
On a '68 RS with the lower side moldings, concerning the doors only, I understand that the clips are of the "T" bolt with nut variety, but I am unsure about the ends (front/rear) - are they fastened with the same acorn nuts or are the end clips of the type that have female threads and take the low-profile/flat chrome plated phillips screw typical of most GM products of that era up through the 80's?
Could anyone post a pic showing the end attachments on an original car?
Would greatly appreciate any input on this.
Thank you.