CRG Discussion Forum

Camaro Research Group Discussion => General Discussion => Topic started by: dannystarr on October 03, 2015, 04:38:51 PM

Title: How were weights installed, Late '68 Norwwood Production
Post by: dannystarr on October 03, 2015, 04:38:51 PM

Getting ready to install Good Year Wide Tread GT's on my original Rally Wheels. Want to use the "MICRO" weights I have collected. How were they oriented? Inside, outside, both? If they hit the trim ring clips, did they switch to the inside, or just spin the tire a few inches and re-balance?.. Danny

Title: Re: How were weights installed, Late '68 Norwwood Production
Post by: JohnZ on October 04, 2015, 05:24:46 PM

Quote from: dannystarr on October 03, 2015, 04:38:51 PM

Getting ready to install Good Year Wide Tread GT's on my original Rally Wheels. Want to use the "MICRO" weights I have collected. How were they oriented? Inside, outside, both? If they hit the trim ring clips, did they switch to the inside, or just spin the tire a few inches and re-balance?.. Danny

As they say, if all else fails, read the instructions (Assembly Manual, UPC 10, sheet A1); wheel weights go on the INBOARD edge of the rim.