Here are a couple of pictures.
The holes in the bumper indicate its a 68 but its does not line up at all, I would imagine the gap between the bumper and panel should be parallel but I don't know because this car never had a bumper fitted when I bought it, I have had to buy the bumper and all mounts to put it back on. Bumper was second hand, inner mounts are second hand, outer are Repro.
If you just hold the bumper up to the front of the car its obvious the "V" is not right, its too shallow.
with the bumper lined up parallel on the drivers side and located with the drivers end bolt it sticks out on the passengers side.
If you try to get the passengers side end bolt in the bumper touches the middle of the front panel long before you get anywhere near the bolt and hole lining up.
Its not twisted or bent that I can see and there are no scuffs on it to show any impact.
Mystery or different car's bumper ?