Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - rare4k

Pages: 1 2 3 [4] 5 6 7
46
Originality / Re: 67 L78 PEOPLE Check in
« on: August 29, 2008, 03:53:12 AM »
I have 27 conv,s on my list I think mike has about 35 conv's on his list.  I'm up to 136 total 4k out of 1138 made ive been doing this list since 1989 when jerry's first book came out and the convertible I had was a 4k car

47
Decoding/Numbers / Re: restamp?
« on: August 08, 2008, 03:10:04 AM »
restamp

48
Originality / Re: Exterior mirror ?
« on: July 25, 2008, 03:39:00 AM »
NOT ALL 67 had the BOWTIE,  I believe most didn't, they are the round mirror with NO BOWTIE

49
Originality / Re: 67 L78 PEOPLE Check in
« on: July 16, 2008, 10:52:24 PM »
plum, it can't win a show but it runs.I guess well have to frame off a 10k mile car

50
Restoration / Re: Markings on Bolts and how to do a "batch" clean
« on: May 28, 2008, 10:59:09 PM »
Are you talking about the body bolts ? or engine bolts ? I think the body bolts would be more the same on all three years, depending on if there from LOS or NOR. I'm sure there were a couple different suppliers for them, But the engine bolts are way different and way to hard. i've been doing research on original bolts for the 67 L78 and have a good sheet for them, let me know if i can help phil.

51
Originality / Re: 67 L78 PEOPLE Check in
« on: May 25, 2008, 05:03:18 PM »
but i have 131 L78 on my list

52
Originality / Re: 67 L78 PEOPLE Check in
« on: May 25, 2008, 05:02:49 PM »
two or three

53
he needs to hit a yard sale to find the clutch fan, ha ha  thats were I found mine,  good luck with the car again and if you get it sold Don't buy anything out there You have one to finish first

54
jerry, if you have time see if you can get me a couple picks of the 67 yenko thanks  and good luck with the car, Phil

55
Restoration / Re: looking for an #1111489 distributor
« on: May 14, 2008, 12:11:26 PM »
I have a   9 - E- 15   1111489 housing only original stamping

56
General Discussion / Re: Camaro Nationals '08
« on: May 14, 2008, 02:02:09 AM »
thursday and friday for parts saturday for the cars to look at.

57
Restoration / Re: camaro two piece rotors
« on: May 12, 2008, 08:51:24 PM »
the outer edge of the hub has a cut back on it to clear the dual calipers,

58
Originality / side mirror manufactures?
« on: May 06, 2008, 02:36:41 PM »
Was there more than One manufacturer on the Camaro side mirrors or Just ( DMI ) Donnelly Mirror, Inc. ?   I picked up a mirror with a ( S ) in between the date codes Thanks  Phil

59
Restoration / Re: 69 DRIVE SHAFT LENGTH
« on: April 30, 2008, 02:45:50 AM »
small block cars are   49 1/2    big block  are 50 1/2

60
General Discussion / Re: Possible find 67 L30/M20
« on: April 21, 2008, 12:25:56 PM »
I think the rear is wrong just by date, should be a 12 bolt round bar,Ithink the car may have had a saginaw trans thats why the cable is on the drivers side, I haven't seen a saginaw in along time I can't remember what side it's on, Also just a NOTE you have a big block cross member  great color when done

Pages: 1 2 3 [4] 5 6 7
anything