Ok .....I will try to give enough info to make this easy, but if I have left anything out, please e-mail me. Mark_sanders@bellsouth.net
My car has a 396 engine in it and is a factory big block, but has a turbo 350 trans. It is mounted to a smallblock crossmember. When I installed the 4 speed and put the big block cross member in, the mount will not line up. The trans is too far to the drivers side. It has the proper big block engine mounts to clear. It is a power brake, power steering car so you know if it had the wrong mounts that would not clear. Do you think it is possible that the previous owner bent something to make it fit? Or do you think if I took the motor mounts loose that I could shift the trans over the 1" it needs to go? Any ideas?
The 4 speed will not shift because the linkage hits the trans tunnel. PS this was a factory turbo 400 car, but it is long gone. THANKS Mark