76
General Discussion / Re: Correct Style Engine Comparment Harness?
« on: February 14, 2016, 05:17:40 PM »
Never seen a Idle stop solenoid on any 69Z.
News:
Welcome to the CRG Discussion Forum!
Classified ads are not allowed on the forum.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
77
Mild Modifications / Re: 4053 Holley carb replacement
« on: February 14, 2016, 03:45:04 PM »
Save your money. You wont notice any difference. 302's are not very streetable to begin with.
78
Originality / Re: Hurst blower motor cage ?
« on: February 10, 2016, 06:07:18 PM »
Jeez, I thought I knew everything. Thanks Bertfam.
79
General Discussion / Re: 67 pace car & 68 Z28
« on: February 10, 2016, 06:05:14 PM »
Ad states he has 40 cars in there. I Don't think the prices are too bad If you want real stuff. Go with some money and negotiate.
80
Restoration / Re: The High $cost of restoration... $135 plastic strap?????
« on: February 10, 2016, 04:23:34 PM »
One can make a living on ebay alone if you know what you are looking at. I always seem to lose money.
81
Originality / Re: Hurst blower motor cage ?
« on: February 10, 2016, 04:17:15 PM »
That is Hurst. Has the shifter through the H.
82
General Discussion / Re: 69 bbc oil pan recomendations
« on: February 09, 2016, 05:21:48 PM »
Ive always used these with good luck.
http://www.milodon.com/oil-pans/oil-pans-from-milodon.asp
They have stock as well as racing.
Love your Labrador.
http://www.milodon.com/oil-pans/oil-pans-from-milodon.asp
They have stock as well as racing.
Love your Labrador.
83
Restoration / Re: Pot metal chrome services / taillights
« on: February 02, 2016, 04:28:13 PM »
The re-chromed parts didn't lose the definition? I don't have good luck with the Pot Metal resto services. And way expensive. If i had a part that wasn't reproduced then there would be no choice but the type of shows I go to nobody can tell its repop. Concourse different story.
84
Restoration / Re: Pot metal chrome services / taillights
« on: February 02, 2016, 04:18:02 PM »
I didn't have a original to compare to only NOS. Lots of sharp casting flash and poor chrome shine on the GM. The customer chose the CHQ.
85
General Discussion / Re: Barrett Jackson today - Gas Moneky COPO...
« on: January 30, 2016, 11:04:14 PM »
From my view the Kindig shop does quality work. The Grease Monkeys are flippers.
86
Restoration / Re: Pot metal chrome services / taillights
« on: January 29, 2016, 11:29:06 PM »
Good job. I had side by side the 69 Camaro gill trim and the CHQ parts were nicer than NOS.
87
Restoration / Re: Pot metal chrome services / taillights
« on: January 29, 2016, 08:17:07 PM »
Scott, What is the problem with the CHQ bezel mounting studs? Differ from originals?
88
Restoration / Re: Pot metal chrome services / taillights
« on: January 29, 2016, 01:11:13 AM »
CHQ's are so darn good no one will know.
89
Restoration / Re: Need tip: installing speedometer grommet
« on: January 29, 2016, 12:17:51 AM »Hi Steve,
It looks like the two are the same. The package I have shows two P/N's of; #55-52/#37-16E
Mike
Thanks Mike, That's a must have tool.
90
Restoration / Re: Need tip: installing speedometer grommet
« on: January 28, 2016, 08:18:18 PM »
Which one did you get? There are 2 available.